I am selling two 6" diameter in and out stainless steel 90deg exhaust elbows. Approximate dimensions 11" x 24". These are repower leftovers and came off my 1973 Chris-Craft 47 Commander with Cummins VT8-370Ms. These were installed under the dry riser water injection point and carried the exhaust to the aft bulkhead in the engine room. The boat exclusively used in the Great Lakes and upper Chesapeake, so these have little corrosion considering the age. $100 each. Located in Toronto, ON - willing to ship at buyer's expense.

I am selling a pair of Marquipt Single Fender Holders for $300.00. These are the style that bolt through stanchions or similar surface. ID is 11.5" and depth is 20" - according to Marquipt these are intended for 10" diameter fenders. Great condition, they came off my boat which has always been in the Great Lakes & Upper Chesapeake, so no noticeable corrosion. Located in Toronto, ON but I am willing to ship at purchaser's cost.

Trident TRL-645 marine 6 inch rubber wet exhaust elbow, 45 degree. New unused, I bought for my boat engine repower project. $50ea, I have two available. Located in Toronto, ON - willing to ship at buyer's cost.

Trident TRL-690 marine 6 inch rubber wet exhaust elbow, 90 degree. New unused, I bought for my boat engine repower project. I have two available, priced at $70 each. Located in Toronto, ON - willing to ship at buyer's cost.

New unused marine wet exhaust hose by Vetus. 6 inch diameter by 20 inches long. Wire reinforced. Leftover from my repower project. $40. Located in Toronto, ON - willing to ship at buyer's cost.

Centek 6 inch diameter fiberglass marine wet exhaust tubing 43 inches long. New, never used during my repower project. $150 Located in Toronto, ON - willing to ship at buyer's cost.